pulse forming line

美 [pʌls ˈfɔːrmɪŋ laɪn]英 [pʌls ˈfɔːmɪŋ laɪn]
  • 网络脉冲形成线
pulse forming linepulse forming line
  1. Research of the Principle of Double Pulse Forming Line in TIA-450 Carbon Ion Accelerator

    TIA-450型碳离子加速器双脉冲形成线原理研究

  2. This transformer can be used to realize the output impedance transformation of the ceramic pulse forming line with low characteristic impedance .

    此变压器可用于低阻抗陶瓷脉冲形成线输出端的阻抗变换。

  3. Breakdown between adjacent turns and output waveform of helix pulse forming line

    螺旋线型脉冲形成线匝间击穿与输出波形的研究

  4. This paper presents a kind of helical pulse forming line which is devised for long pulse accelerator research .

    本文设计了一种用于600kV长脉冲功率源研究的Blumlein型螺旋脉冲形成线。

  5. Pre-pulse phenomena in pulse forming line charging-up by long pulse energy sources through a transformer

    长脉冲能源给脉冲形成线充电过程中的预脉冲现象

  6. A compact output switch for a water pulse forming line ( PFL ) e-beam accelerator was designed .

    介绍了一种水介质脉冲形成线强流电子束加速器的输出开关的设计和实验结果。

  7. In addition , to study the response characteristics of the induction cell , a rolled strip pulse forming line with an impedance of 3 ?

    另外,为了研究10级IVA单个感应单元的响应特性,研制了一台输出阻抗约3?,脉宽约230ns的Blumlein型卷绕型带状脉冲形成线。

  8. The configuration and simulation model of water pulse forming line switch with prepulse suppression ground plane ( PPS ) were introduced in this paper .

    介绍了具有预脉冲屏蔽板的水介质脉冲形成开关的结构和等效电路模型,给出模型中等效参数的计算方法。

  9. It can reduce the length of the pulse forming line on the premise of forming the same output pulse width to adopt a helical structure .

    采用螺旋形结构的脉冲形成线能在形成同样脉冲宽度的前提下大大缩短形成线的长度。

  10. The influence of the impedence mismatching between the joint section in pulse forming line and the helical line on the voltage waveform of the diode was analyzed .

    为消除输出脉冲的前沿上冲和后沿拖尾现象,分析了脉冲形成线中的连接段与螺旋线阻抗的不匹配对输出波形的影响。

  11. The theory and characteristic of a compact Tesla transformer are introduced , and an unitized configuration design is performed for 1.0 MV , 100 Hz Tesla transformer and 40 Ω, 40 ns pulse forming line ( PFL ) .

    介绍了紧凑型Tesla变压器的工作原理和功能特点,在此基础上对电压1.0MV、重复频率100Hz的Tesla变压器和阻抗40Ω、宽度40ns的脉冲形成线(PFL)进行了一体化结构设计。

  12. A 4 MV water pulse forming line switch that would be used in a water pulse forming line machine was designed based on the experiments of the 1 MV water self-breaking switch . The designed breakdown voltage is 4 MV with a current about 600 kA .

    在1MV水介质自击穿开关降压实验的基础上,设计了用于脉冲功率装置的水介质输出开关,设计的最高运行电压为4MV,放电电流600kA。

  13. A ( 500 kV / 400 kA / 100 ns ) z-pinch device was constructed using a Marx generator , a pulse forming line ( PFL ), a gas-filled V / N field distortion switch , a transfer line , and a z-pinch load .

    输出参数为500kV/400kA/100ns的快速z箍缩(z-pinch)装置由Marx发生器、脉冲形成线、充气型V/N主开关、传输线及负载组成。

  14. The traditional power conditioning scheme uses a pulse transformer and sometimes an additional capacitive pulse forming line ( PFL ) to improve the output waveform , making the system bulky .

    传统的脉冲功率调制电路需要脉冲变压器,体积庞大,若其后再采用传输线作中间电容储能,尽管输出波形有改善,但体积更大。

  15. The operative repetition rate and miniaturization are important to the application of pulse power generator . This paper presents the high power repetitive pulse generator which consists of Tesla transformer with special magnet core and coaxial pulse forming line .

    介绍了一种由Tesla变压器和同轴脉冲形成线组成的高功率、高重复频率的脉冲发生器,其特点是结构紧凑,容易实现小型化。

  16. In pulse power field , the high power pulse transformer type charging system with storage capacitors is widely used to substitute the traditional Marx generator for Pulse Forming Line ( PFL ) charging , because of its compact structure , small volume .

    在脉冲功率领域,脉冲变压器型充电系统具有结构紧凑、体积小等特点,所以常用电容器对其放电来代替Marx发生器给加速器的脉冲形成线(PFL)充电。